Permanent Magnet DC Generator - Magnets: Two high-energy saturated C8 ceramic magnets. - Shaft: Stainless steel 12.7mm (1/2") diameter, 40mm length, with 1mm full-length flat. - Armature: 16-slot armature 52mm diameter would with AWG25 magnet wire (fusing current:24 amps). - Brushes: Extra-long 8x14mm brush assemblies including spring, pigtail, and cap - replacement stock no. 443729 - Bearings: Two double-sealed 32mm OD ball bearings - replacement stock no. 171110 - Rotation: Either direction - The red output wire is positive for clockwise rotation from the shaft end. - Speed: Zero to 5,000 rpm - generates at all speeds Mounting: Four 6mm holes on the front or rear end caps, or by hose clamps on the magnet drum. - Weight: 4.2Kg (9.2lb) Shipping weight 4.6Kg (10lb), dimensions 150x150x300mm (6x6x12in). - Resistance: Internal resistance 7.7 ohms. Inductance 16mH. - Performance: See performance curves below - Maximum charging current is 10A (see run times below) If you exceed these specifications, the generator will overheat and short.
10A -5 minute run time 4A - 30 minute run time 3.3A -60 minute run time 3A -CONTINUOUS DUTY
3A Permanent Magnet DC Generator Low RPM 
Permanent Magnet DC Generator
